UV system PURE 2.4 75 watts for the disinfection of water

1-stage 20 "house and well water filtration with selectable filter The filter system is connected to the central water pipe at the entrance to the water meter.Filter housing and the filter head with vent valve are made of food-safe and high-strength plastic and are of extremely high quality. We have consciously decided in the housings from Prime Inventions GmbH against cheap solutions from dubious origins.Data for a filter unit:Total height: approx. 615 mm to the top of the ventilation valveDiameter of the housing head: 185 mm without connection nipple, with connection nipples approx. 225 mmCurb weight: 3.4 kgDimensions: total height to upper edge of vent valve: 343 mmEach individual housing is included as standard in the scope of delivery: wall bracket painted white with 4 stainless steel housing screws, 2 pieces 1 "plastic housing nipples.One housing key and 2 each of 1 "stopcocks are included in each complete filter system. General information about the Aqua Fidelo water filtration systems Aqua Fidelo is a water filtration system for individual houses, multiple residential units and industrial applications. It can be filtered city water and well water. When filtering well water, we recommend a prior water analysis in order to be able to optimally adapt the system. The system is available in the expansion of one to four housing units. This allows you to install Aqua Fidelo exactly to the required filter performance on site. Water output per minute Depending on the required amount of water, Aqua Fidelo is available in 10 Zoll (one accommodation unit) or 20 Zoll case (two accommodation units). The water performance of the sediment and activated carbon filters in the Aqua Fidelo 10 is around 20-25 l/min. And in the Aqua Fidelo 20” around 40-50 l/min., depending on the water line pressure. In the systems with iron filter cartridge, the water flow bottleneck is the iron filter cartridge. The 10” iron filter cartridges have a water capacity of approx. 9 l/min. The 20” iron filters have the double flow rate of 18 l / min. The limescale protection cartridges 10” and 20” have a water flow of 24 or 48 liters per minute Safety instructions: Only suitable for cold water operation. Installation must be carried out by a sanitary facility specialist! For safety reasons, we recommend a drain in the vicinity of the filter system. The installation is only with a pressure reducer, adjusted to max. 4.5 bar, and a backflow preventer allowed.   Information about the selectable filter cartridges Sediment filter standard Standard sediment filter 10 my fineness, made of polypropylene foam. Ideal for removing the following mechanical impurities from the water: sand, mud, rust, river mud, pollen… Service life: The filter cartridge must be replaced after 6 months (according to DIN 1988). Basically, 16.000 (10 ") or 26.000 (20") liters of water may be filtered within the 6 months. Technical data: Flow rate: 50 liters (10 ") or 60 liters (20") per minute (depending on the water pressure) Use only with cold water, protect against frost Sediment filter Premium (Pentek) Pentek ™ 2-stage sediment filter (outside 25 my, inside 1 my). In the outer layer, which is about 5 cm thick, all substances are held larger than 25 my, in the inner layer is an additional about 5 cm thick filter fleece with the filter density 1 my. As a result, the filter cannot clog so quickly compared to conventional sediment filters. Service life: The filter cartridge must be replaced after 6 months (according to DIN 1988). Technical data: Flow: 40 liters (10 ") or 60 liters (20") per minute (depending on the water pressure), Use only with cold water, protect against frost Carbon filter standard Standard activated carbon filter 10 my fineness. Filter performance: Odors and bad taste in the water, retention of small particles, retention of chlorine and other similar undesirable substances, retention of various heavy metals such as lead, etc., retention of organic compounds Service life: The filter cartridge must be replaced after 6 months (according to DIN 1988). Basically, 16,000 (10 ") or 26,000 (20") liters of water may be filtered within the 6 months. Technical data: Flow rate: 30 liters (10 ") or 40 liters (20") per minute (depending on the water pressure). Use only with cold water, protect against frost Carbonfilter Premium (Pentek) With this filter cartridge, it is possible to filter very large amounts of water at the house water inlet very fine. The fineness of 0.5µm is extremely small for this type of construction (otherwise in the domestic water inlet usually 5µm or 10µm). This makes it possible not only to remove odors from the water, but also to reduce some pollutants in the water. These include e.g.: heavy metals, pesticides and drug residues. Despite the high fineness of the filter cartridge, the water pressure only decreases by approx. 0,5 bar. Service life: The filter cartridge must be ready after 6 months (according to DIN 1988). Technical data: Flow: 20 liters (10 ") or 30 liters (20") per minute (depending on water pressure). Use only with cold water, protect from frost. Iron filter Effective reduction of dissolved iron in the water. Service life: The filter cartridge must be replaced after 6 months (according to DIN 1988). Technical data: Flow: approx. 9 liters (10 ") or 18 liters (20") per minute. Use only with cold water , protect against frost. Anti limescale cartridge The catalyst granule flows through the seed crystal principle. This precipitate lime is bound to the seed crystals and floats in the water with away. The procedure serves to protect the line and devices. Limescale deposits can be easily removed / wiped off after use. Lime removal, however, does not take place. Duration of use: When used with drinking water quality water without coarse sediments, the catalyst granulate lasts about 3 years. Technical data: Flow: 24 liters (10 ") or 48 liters (20") per minute (depending on the water pressure). Use only with cold water, protect against frost.