Injector & Connection Set for SYR NeoDos 3100 Connect (Stand-Alone) DN 20

With the SYR dosing pump NeoDos 3100 Connect, mineral solutions are added to the drinking water. The mineral solutions prevent corrosion and limescale formation, raise the ph-value of the water or are used e.g. after a softening system or to stabilize the hardness of the water in copper or galvanized pipelines as well as in mixed installations. The dosing system meets the requirements of DIN 19635. The NeoDos Connect dosing pump detects the flowing water volume by means of a water meter and thus determines the addition of minerals from the dosing tanks, which are pumped into the pipe via the dosing hose. Optional dosing solutions (not included) With the mineral solutions DL 1 and DL 2 different solutions from SYR are available. The mineral dosing solutions DL 1 and DL 2 are approved drinking water additives and comply with the requirements of the Foodstuffs Act, the Additives Ordinance and the Drinking Water Ordinance. They contain phosphates and silicate combinations designed to protect drinking water systems. The special phosphates prevent corrosion and rust water formation and stabilize water hardness. Phosphate is an essential mineral for the human body and occurs naturally in many foods. The phosphate used in the solutions meets the strict requirements of DIN/EN and is highly pure. The daily requirement of an adult is 700 mg of phosphate. On average, people consume 1,092 g of phosphate per day with dairy products and approx. 1,068 g with meat and sausage. By comparison, if phosphate is added to drinking water by means of a dosing solution, only 4 mg is consumed daily. Which dosing solution is the right one for me? DL1 (hardness stabilization + corrosion protection) is used for hardness levels > 14 °dH without a water softener. DL2 (corrosion protection) is used for hardness levels < 14 °dH with a softening system. Important information for ordering For use without a water softener (stand alone), the "Inoculation piece incl. connection set" must be ordered separately in the correct nominal size DN 20-DN 32: DN 20: 3100.20.000 DN 25: 3100.25.000 DN 32: 3100.32.000 Alternatively, when operating with a water softener (LEX Plus 10 Connect series and Neosoft), the Lex Plus / Neosoft connection set (3100.00.011) must be ordered. More information can be found in the operating instructions, which can be found at the article under Downloads.