Sand filter & particle filter Hydrocyclone F 710 for sanded wells

699,00 €*

Indhold: 1 Stück
Stück
Varenummer: 1705
Hersteller: YAMIT
EAN: 4260728213366
Mit dem Sandfilter & Partikelfilter Hydrozyklon F 710 wird ein versandeter Brunnen wieder einsatzfähig gemacht. Schluss mit Scheibenfiltern die ständig zu sind. Durch die spezielle, von Ingenieuren entwickelte Abscheidungstechnik, werden Sand und schwere Partikel in einen Sammeltank abgeschieden.
Produktinformation "Sand filter & particle filter Hydrocyclone F 710 for sanded wells"

The Hydrocyclone F 710 was developed by engineers for the separation of sand and other sediments, originally for horticulture and agriculture.

The Hydrocyclone type F710 from the manufacturer Yamit is specially designed for the problem of silted wells. The hydrocyclone is mostly used in horticulture or agriculture and thus represents a profile solution. Therefore, we offer here the smallest version, as it will be more than adequate for most private well operators. The device works from a minimum throughput of 2.4 m³ / h - 4m³m / h. Please make sure that this service required for the operation is at your disposal. The device does not require an electrical or wastewater connection. In winter, it must be protected by venting against frost.

On the function of the hydrocylone

Water enters the hydrocyclone via the tangential inlet, creating a spiral flow along the filter walls. The centrifugal force separates the waste and sand particles and pushes them against the walls of the sand separator. These particles float down into the sedimentation tank while clean water flows upwards and exits through the upper outlet. The pressure loss is only 0.2 and 0.5 bar. The separation efficiency is not affected by the accumulation of dirt in the settling tank. The sedimentation tank is emptied by manually opening a purge valve for a few seconds. The collecting tank has a filling capacity of 2.5 liters.

Subsequent Filtratrion

As a subsequent filter, you should use a commercially available disc filter.

Other sizes?

If you need a more powerful version, please contact us. The hydrocyclones are available up to a capacity of 330m³ / h.

Durchfluss: mind. 2,4m³/h - 4,0m³/h
Material: Carbon Stahl ST 37.2
Technische Details - Sand filter & particle filter Hydrocyclone F 710 for sanded wells

Material: Carbon Steel ST 37.2
Connection: 3/4 "
Tank volume for the sand: 2.5 liters
Exterior and Interior Coating: Electrostatic, oven-baked polyester-epoxy powder coating 150-200 microns thick
Connections: VIC, male thread and flange
Recommended maximum working pressure: 10 bar
Equipped with vacuum valve

Downloads - Sand filter & particle filter Hydrocyclone F 710 for sanded wells